Installation and Configuration Supplement

Using the Command Line Processor to Configure Server Communications

This section describes how to configure your server to accept inbound requests from remote client workstations. Also described in this section are considerations when configuring the DB2 Administration Server for communications. The Control Center and the Discovery function of the Client Configuration Assistant (CCA) are dependent on the Administration Server's protocol configuration.

Follow the instructions in this section if:

• You deselected a detected communication protocol during the installation;

• You have added a communication protocol to your network since running the DB2 setup program; or

• You are using a communications protocol that could not be detected by the DB2 setup program.

You can use the Control Center's Setup Communications function to configure an instance for communications; however, it cannot be used to set up communications for an Administration Server or a DB2 Enterprise - Extended Edition server. For information on how to set up communications using the Control Center, see Using the Control Center to Configure Server Communications.

For instructions on entering DB2 commands, see Entering Commands Using the Command Center or Entering Commands Using the Command Line Processor.

[ DB2 List of Books | Search the DB2 Books ]