Capturing state changes

Perform the following steps in System Monitor to configure how state changes for each component are captured and sent to a log file:

  1. Click Set Options in the left frame of System Monitor. The Set Options dialog box appears.
  2. Under the Do you want to capture state changes of a particular component? section, select the component from the Component Type list.
    Note:
    If you selected Collaboration or Connector as the component type, you are prompted to select a particular collaboration object or connector.
  3. Select the Capture State Changes check box, then click the Submit button in that section.

See also:

System Monitor overview

Contents of the System Monitor Web page

Logging on to System Monitor

Customizing data in System Monitor


[ Top of Page | Previous Page | Next Page | Table of Contents ]

Copyright IBM Corp. 2004