Set archive -- Controls

Reset to default values

Set values

Reset to default values

Select this radio button to reset the archive values back to those specified during DB2 installation.

Set values

Select this radio button if you want to set values for the tape unit limits for the archive. After you select this radio button, you can:

• Limit the number of tape units:
  1. Click the Maximum number of tape units checkbox.
  2. Type an integer from 1 - 99 to specify the maximum number of tape units that can be dedicated to reading archive logs. This value affects the allowed concurrent reads for unique archive data sets residing on tapes.

     If the number specified is greater than the current specification, the maximum number of tape units allowable for reading archive logs increases. If the number specified is less than the current specification, tape units that are not being used are immediately deallocated to adjust to the new value. Active tape units remain allocated; a tape unit is a candidate for deallocation because of a lower value only if there is no activity for the unit.

• Specify a time limit for unused tapes:
1. Click the Length of time a tape can remain unused before deallocation checkbox.
2. Select a radio button:

   No limit

   Specifies that a tape should never be deallocated.

   Specifying no limit is equivalent to TIME(1440). The seconds specification is not allowed when you specify that TIME is 1440.

   Duration

   Specifies the length of time that you want a tape to be used for archiving. After making this selection, type the number of minutes and seconds that you want.

   Minutes must be an integer between 0 and 1439.

   Seconds must be an integer between 1 and 59.