Release Notes

6Restrictions to adding products using the db2setup command

6Once a DB2 product has been installed, additional DB2 products can be 6added. If you use the db2setup command to add products the 6following recommendations and restrictions apply.

6Recommendations

6Both the installed product and the product being added should be at the 6same code level. For example, DB2 ESE Server Version 8 FixPak 5 is 6already installed and you want to add the DB2 Information Integrator 6product. In this case, DB2 Information Integrator should also be at the 6Version 8 FixPak 5 level.

6Restrictions

6

• 6If the DB2 fixpak level is higher than the fixpak level of the product 6being added, the combination is allowed. However, since the fixpak 6level of the product being added is lower than the DB2 fixpak level, the DB2 6fixpak level must be reapplied after installing the additional product. 6See the appropriate FixPak Readme for instructions to reapply the 6fixpak.
• 6If the DB2 fixpak level is lower than the fixpak level of the product 6being added, an error is generated. The product being added cannot be 6at a higher fixpak level than DB2. In this case, you must first bring 6DB2 to the appropriate level, then install the additional product. See 6the appropriate FixPak Readme for instructions. 6

6The following table summarizes the db2setup combinations:
6

6Table 5. db2setup combinations

6The DB2 Support Web site address is http://www.ibm.com/software/data/db2/udb/winos2unix/support