5761XE1 V6R1M0 IBM System i Access for Windows

In this directory is a fix for V6R1M0 System i Access for Windows CORE
that is not in the SI31251 service pack:

APAR SE33244: CA400EXP-OPNAV-INCORROUT CENTRAL SYSTEM CHANGE PROBLEM
        Attempting to change the System i Navigator Central System may result in
        the application not responding
 


This fix ONLY applies to V6R1M0 service pack SI31251.  Please do not attempt to
apply this fix to any other release of System i Access for Windows, or any other
service pack level.

If you need to contact Service about problems with these modules, you should
mention that you are using the cwbcore.dll file from the ftp site and the
se33244 directory.

The file size and install location are as follows:

  cwbcore.dll    1,134,592 bytes   (Windows system directory)

Note: The default Windows system directory is:
  C:\Windows\System32

This fix is applied by replacing the file or files on a PC with those that
contain fixes.  If you later re-install a service pack or the entire
product, the testfix file(s) will be overwritten.

File replacement instructions
------------------------------------------------------------------------------
For each file in this fix:
1) Locate the file on your client workstation, in the location noted above.
2) Back up the old file by copying it and adding ".bak" to its name.
   For example: cwbcore.dll would be copied to cwbcore.dll.bak
3) Copy the fix version of the file into the same directory.  If this file
   is in use and cannot be replaced, copy it to the directory by adding ".new"
   to its name.
   For example: filename.exe would be copied to cwbcore.dll.new
4) If one or more of the files in this fix could not replace the old one,
   shutdown the PC and re-start it in safe mode with no networking; then
   copy each .new file to the actual fix filename.
   For example: cwbcore.dll.new would be copied to cwbcore.dll
5) You may need to shutdown and re-start Windows normally for the fix to
   fully take effect.